Hello,
I recently started using SBFspot, version 3.1.1 on raspberry pi.
I have a two inverter system. Both are successfully being queried.
As both inverters are part of my single PVOutput system, I have:
```
PVoutput_SID=2100397497:XXXX,2100393920:XXXX
```
This results, ultimately, in just one inverter's data being added to the site.
It is possible to see the first inverter's data being presented, and then over-written with the second.
If there are multiple inverters and the SIDs are the same, it would make sense to add the data, no?
I recently started using SBFspot, version 3.1.1 on raspberry pi.
I have a two inverter system. Both are successfully being queried.
As both inverters are part of my single PVOutput system, I have:
```
PVoutput_SID=2100397497:XXXX,2100393920:XXXX
```
This results, ultimately, in just one inverter's data being added to the site.
It is possible to see the first inverter's data being presented, and then over-written with the second.
If there are multiple inverters and the SIDs are the same, it would make sense to add the data, no?